View Single Post
Old 02-09-2012, 03:18 PM
yoda604 yoda604 is offline
Not a Newbie
Join Date: Apr 2010
Location: Langley
Posts: 586
yoda604 Good newbie
Reputation: 11
Originally Posted by bcmaxx View Post
was the motor out? tried another crank position sensor? I broke mine when I took my engine out ( bellhousing). And all four of those little wires are intact that go between the dipstick tube mount bolt and wiring hrness at firewall? I had one broken, but not visible, caused me problems until I finally found it
The crank shaft position sensor checks out perfect. If I have time tonight I will double check those grounds. I believe one of them is for the magnetic pick up on the distributor, so it could definitely cause problems. When I look I will let you know
The safe word is HWhisky
Reply With Quote