PDA

View Full Version : stuck and need help with SAS


Bigsexy
02-23-2009, 01:12 PM
im lookin for someone in the lowermainland area that has experience with sas.. im in the middle of swapping out my ttb junk for a 79 bronco d44.. truck is a 96f150 and all susp components have been removed now.. i just need help on where to drill and mount my radius arms so the diff is perfectly straight.. I will pay for beer n food/pay ya' or w/e for helping, i just need someone who has dun it b4 and no's what there doing to walk me threw it..
let me no if u can help in any way.. thanks [cheers]

F150HULK
02-23-2009, 07:20 PM
Find Hulk and get Blue prints with pics. :confused0006:

fin96
02-23-2009, 08:55 PM
its super easy just mock up axle as close as possible to ride height and throw plumb bobs threw your coil bucket holes and manuver axle until the bobs are in the center of coils cups, set your caster then drill holes for radius arms wherever they end up on frame. might need degree bushings for your radius arms depending what your using for arms and drop brackets... then build your track bar mounts so the bar is on the same angle as your draglink and your golden

StinkFinger
02-23-2009, 10:38 PM
i may of have done this before where you at

Arnee
02-23-2009, 10:58 PM
i think i've seen that truck parked in abby.

Bigsexy
02-23-2009, 11:15 PM
i may of have done this before where you at

abbotsford.. just off abby/mission hiway..
arnee: u possibly seen it on the side of my house..

bigorange440
02-24-2009, 12:02 AM
i seen the truck the other day ..was wondering whaat ya were doing..i could stop by one night and give ya a hand

Arnee
02-26-2009, 12:57 PM
abbotsford.. just off abby/mission hiway..
arnee: u possibly seen it on the side of my house..

yea i saw the crawlin sticker and stainless bumper. was driving home from my buddys gfs house[cheers]