PDA

View Full Version : dana vrs 10 bolt combos


ROBO
01-11-2009, 02:33 PM
well fixin my front wheel hubs .. and find out that the spare parts i got aer frome a gmcorp 10 bolt front, now the d44 im runnin needed new stub shaft spinle nuts. now the 10 bolt one is in great shape, so i put it on .. but i find out it uses much larger inner bearings than the d44,so can i switch the bearing and races out of the rotors or just use all the 10 bolt stuff on the out side?

trencher
01-11-2009, 08:55 PM
I don't think so
The 10 bolt is a whole other beast from a 44 as i understand

importcrusher
01-11-2009, 09:39 PM
the spindle looks similar but im prety sure it wont work

pumpkin
01-12-2009, 06:28 AM
There are two sizes of spindles. Ten bolt and d44 are the same from the u joint out.