PDA

View Full Version : wanna get a drive shaft made up


spitty
11-05-2008, 09:20 PM
whats it worth to get a drive shaft made? for a rear?

Dr.Ford
11-05-2008, 10:29 PM
got mine at pat's driveline in port kells. 307.84

D-Ass
11-05-2008, 11:37 PM
give danco a call in port kells that is who we use for all our drive shafts [cheers]

barracuda
11-05-2008, 11:42 PM
if it needs to be made shorter then pats is about $75.

dirka dave
11-05-2008, 11:53 PM
Pats driveline is always a good place...

pumpkin
11-06-2008, 07:47 AM
I can do it,,,,,,,I don't have a lathe so it takes me a bit longer. I can do it for about $150.

Tinker
11-06-2008, 03:55 PM
CV style or slip yoke or......? Price depends on what you need. I'd say $350-$700 @ a shop.

Cheeky
11-06-2008, 04:25 PM
400.00 at pats,fukin killer job,custom front to back and 10 inches slip in it[36]

spitty
11-06-2008, 04:50 PM
CV style or slip yoke or......? Price depends on what you need. I'd say $350-$700 @ a shop.
solid 1 piece thinger

http://www.innerauto.com/images/partImages/driveshaft1.jpg

pretty much like this but i have the ends already

Tinker
11-06-2008, 06:01 PM
solid 1 piece thinger

http://www.innerauto.com/images/partImages/driveshaft1.jpg

pretty much like this but i have the ends already

That would be a slip yoke style the end thingys are the yokes.

Happypants
11-07-2008, 02:19 AM
pats did both my front and rear, shortened the front, about 100 bucks, lengthened the rear just over 300, IMO was worth every penny, they even rebult the double cardigan joints on them, keep em well greased with lots of lucas grease and 2 years later havent had to replace a u-joint yet!

MUD CHILD
11-07-2008, 12:09 PM
MudRam builds drive shafts, He built mine, both on the Zuk and on the Chevy. Nice work and very reasonable price

J20
11-07-2008, 12:17 PM
drive products in port kells did mine for the j20

SHORTBOXCHEVY
11-08-2008, 07:26 PM
if you got the ends already i believe its somwhere around 2$ an inch, at pats drivline

HILLBILLY
11-08-2008, 08:56 PM
hey Tyler do you need shortend or longer?

spitty
11-09-2008, 04:01 AM
hey Tyler do you need shortend or longer?
longer

HILLBILLY
11-09-2008, 03:30 PM
longer
give me the lenght and pipe dia. I can make it for you