View Full Version : need help with 2wd ford wheel bearings
10-11-2008, 02:47 PM
does any one know what you are supposed to torque a spindle nut on a 2wd ford e350 to?
10-11-2008, 04:59 PM
Usually I just crank it up til it's snug with a pair of smaller channel locks, then spin the rotor to make sure it spins freely, then usually either tighten it just a bit to loosen it just a bit to line up the cotter pin keyway in the nut, just don't leave it so loose, a wee bit of preload is not a bad thing.
10-13-2008, 10:12 PM
just do it up snug till all the play is gone then put the cotter pin back in. if you need more just call me. 778 558 0316.
10-13-2008, 10:35 PM
i phoned my aunt at the dealership and she faxed over the "factory recommended" instructions for putting them in
vBulletin® v3.6.4, Copyright ©2000-2017, Jelsoft Enterprises Ltd.