PDA

View Full Version : how do you tell???


Bigsexy
10-06-2008, 05:28 PM
how do u tell the difference between thin and thick cut d44 4.56gears? is there a obvious difference by looking??

Nutbar
10-06-2008, 05:51 PM
unless you have both sitting side by side it will be very hard to tell the difference is only around an 1/8 of inch difference

Bigsexy
10-07-2008, 05:40 PM
well shit eh... does anybody have a 4.56 RnP kicken around i can compare with then???

Happypants
10-12-2008, 10:33 AM
for one, you wont be able to get the cross pin out as easly if you have a thick cut ring gear, and i think there should be a T next to the ratio on the ring gear itself if im not mistaken,