PDA

View Full Version : Lordco??


FordMclovin
10-04-2008, 01:39 AM
Hey...
I went into lordco today and there was a young kid working. I asked if he could look me up a Cj7 floorpan... No match he said they dont have them??? He said they can bring in tubs..... So my next question is what gage of metal should I use to do floor pans or if you know where I can get already pre made ones?
Thanks
And what gage should i use for panels?

turbomustang
10-04-2008, 01:50 AM
21 gauge sheet metal.

Trooper
10-04-2008, 11:14 AM
Thicker the better. Easier to fit. I always use at least .065 most older sheat metal is .042 new shit I seen as this as .017

B
10-04-2008, 11:58 AM
the yj ones he can get will be very close match about 70 bucks each

Rye Guy
10-04-2008, 12:27 PM
Ther should be an online source did you try that?

YJ
10-04-2008, 04:28 PM
I would use 18 GA (0.044") min. 16 GA (0.055") better.