PDA

View Full Version : 79 power wagon rotor


s10 broad
08-25-2008, 04:26 PM
well i need to how the fuck to take off the front rotor on the 79 power wagon.. do they just slide off with a puller or is there more work involved then that .. any help please!!!

epic3
08-25-2008, 04:49 PM
1/2 ton 3/4 ton 2wd or 4wd?

Always broke
08-25-2008, 05:05 PM
Is it the full time 4x4 with the 1 1/8 outer nut?

Maelthra
08-25-2008, 07:07 PM
Read if your truck has a Dana 60 front axle:

Pull the hub/Drive flange: Remove the 2 9/16ths" spindle nut, there may be a locking ring behind it, slide it out, remove the other 2 9/16ths" spindle nut. Remove the bearing.

Pull the rotor off, be careful not to drag the grease seal over the spindle threads if you plan on keeping it in there.

Good time to repack your bearings, too.

s10 broad
08-25-2008, 08:09 PM
it is my cousins truck and we were told that after everything is removed that the rotor should just need to be pulled off .... with a puller of course... it is a 3/4 all time 4x4...

Always broke
08-25-2008, 09:19 PM
did you take off the bearing retain nut? just spin it to see where it is being held from shouldn't be that hard to get off unless seized onto the spindle then you need a die grinder

s10 broad
08-25-2008, 11:36 PM
we took the nut off.. i m pretty sure it si siezed ..we were pulling pretty hard on it ...

crazylike
08-26-2008, 10:09 PM
hit it with a hammer

s10 broad
08-26-2008, 10:31 PM
did that .. pretty hard too.. i think it has just been on there way to long..:mad:

crazylike
08-27-2008, 01:30 PM
i have a d44 front axel and d60 rear matching set 60000kms on em 250 bucks for the set you pick up.