PDA

View Full Version : best way to cut indepndent suspension off


toyon35s
07-07-2008, 05:55 PM
just like it says,i was thinking grinder with ip blades but lookin for more options let me know what you would use[cheers]

HEAVY METAL
07-07-2008, 05:56 PM
rent a plasma

hoser
07-07-2008, 06:01 PM
when i did my swap i used a grinder...fucken sucked..definitly borrow some torches or plasma cutter...

TWOZEROFOUR
07-07-2008, 06:14 PM
arc welder @ 200 amps,,, worked grate [36]

toyon35s
07-07-2008, 06:42 PM
were would one find a plasma to rent?:confused0006:

goonie
07-11-2008, 07:21 AM
i used a grinder with a cut off blade and a sla saw with a huge ass blade. plasma for the most part would be nice but its not needed. i had all the frontend off and cleaned in a day, so it wasnt that bad. have fun ,and after u'll never drive a indpent. front end again

ri0
07-12-2008, 11:25 AM
I have done 4 SAS so far two with grinders and two with plasma, grinder will take you most part of one day to get it off...plasma I had everything out in just under an hour....

dirka dave
07-12-2008, 12:50 PM
Just yell really loud at it.

.

Troy
07-12-2008, 06:29 PM
oxy-fuel torch. reliable, easy to use and quick. spasma also have to have a compressor which not everyone has. if you get the tip too hot on the plasma or are using it overhead its really easy to burn the inner tip up. and they are close to $20 each.

trevyota
07-13-2008, 03:21 AM
plasma......... or a torch...


grinder and sawzall just wastes time...

you should be able to do the complete sas in a day if your diff is pre assembled...

dirka dave
07-13-2008, 12:46 PM
Torch my friend, torch...

sj-x 500
07-13-2008, 07:31 PM
the cheap plasmas have a built in compressor...

but plasma all the way. just gotta give it a place to start with a grinder then fly at it, clean it up with a grinder

Ironman
07-13-2008, 07:52 PM
a judo chop