PDA

View Full Version : How does this come apart.


girlcrazy_4
04-13-2008, 03:45 PM
How does this piece come apart? It is for the slave inside a m5od. The hydrolic line attaches to it. Also at the master cyl. How does that line come out? Just a metal pin?

http://i21.photobucket.com/albums/b252/Impulse_rs/cid_0413081537.jpg

toyon35s
04-13-2008, 03:49 PM
im not sure but wouldnt you just buy a whole new piece?:dontknow:

girlcrazy_4
04-13-2008, 03:59 PM
Because there is nothing wrong with it.

toyon35s
04-13-2008, 04:00 PM
Because there is nothing wrong with it.

then why take it apart?:confused0006:

boyzen
04-13-2008, 04:47 PM
there should be a plastic sleve on the one end that you need to push in to get hte lie out thats on slave side the other is the metal pin that you see.

dirka dave
04-13-2008, 04:49 PM
:dontknow: Try a 20lb slege hammer....:dontknow:
Thats how I usually deal with Fords..:D

[cheers]

boyzen
04-13-2008, 04:51 PM
that line is like 80 bucks so I hope you have the old one

girlcrazy_4
04-13-2008, 05:40 PM
alright so I was doing it right. Push the sleeve down... I broke my other one doing that, so I was hoping for a easier method. When I get a new line, the sleeve will just come back out when I push the new line in?

And no... I didnt save the line. Couldnt figure out the clip and I needed the tranny out so I could finish the job. I figured $20 at lordco... but they're n/a... dealer is $79 but pick and pull is $2 :D

girlcrazy_4
04-13-2008, 05:41 PM
then why take it apart?:confused0006:

If you dont know what it is, or what it is; than why post? If I wanted a new one, I would've gone that route.

strokenit
04-13-2008, 08:00 PM
If ya plan on beatin the truck now is a good time to put in a ZF

boyzen
04-13-2008, 08:09 PM
yep your doing it right then,they are a fucker to get as long as you are more stuborn than it you will get it. when the new line goes in it will pop out.oh and carfull with te o ring at the master side they are a weird size so no one has them .

girlcrazy_4
04-13-2008, 08:38 PM
The one I mentioned that I broke... I got the sleeve in (or so I think it is) but I chewed it to fuck with a screwdriver and it still never came apart. reccomendations before I smoke a good sized joint and tackling this?

edit: Have you seen the tool for this? It looks like a fucking nail puller.

boyzen
04-13-2008, 09:25 PM
hmmm not sure never had that much problem ,but maybe try a flat pry bar

Cwheeler
04-16-2008, 06:43 PM
ahh the little tool makes life easier, if you fuck up that white plastic ring your never gonna get it to clip back in again, just buy a KD one at lordco, dont fuck up the packaging, use it, and take it back when your done :)

radman
04-19-2008, 06:39 PM
wd 40 and compressed air they like to collect dirt and it stops the color from going down