View Full Version : Need some ideas!

02-21-2008, 08:10 PM
ok, so i purchased a 2.5in bore by 8in stroke ram to finish hookin up my hydro assist steer, problem is im havin a b@#ch of a time figuring as to where i can mount it on my dana 60, at full stroke it wont fit under the leaf packs there 10in arcs. Any ideas besides coilovers? there must be a way just not picturing it.

02-21-2008, 09:10 PM
hers a couple pics of brothergrimms freont end..



02-22-2008, 06:16 PM
that truggys is sweet, yah im only gona run the hydro assist, not runnnin full hydro steer. i like the fab work of that diff steer n ram sheild. im thinkin i should wait n run wut i got, then build somthin similar to brothergrimms front diff n run full hydro steer!:confused0006:

02-23-2008, 02:42 AM
8" stroke is a bit too much i think

from what i've seen and what i have on mine is a 6'' stroke and its plenty.

you can mount one end off the diff cover if you've got a thick ring that bolts on.

i mounted mine off the top of a u bolt plate cause i had no other choice of the reverse mounted tie-rod


02-23-2008, 11:49 AM
Hey Troy did u make or buy those revers mounted tie rod top plates?

02-23-2008, 05:50 PM
Hey Troy did u make or buy those revers mounted tie rod top plates?

i got my highsteer arms from northwest fab on the island


really nice quality products, and good service too.