PDA

View Full Version : 1350 cv


78bronco
02-05-2008, 02:21 PM
looking for info on 1350 CV's what did they come in and how strong are a stock cv compared to after market and how much angle can I expect to get out of them?

epic3
02-05-2008, 05:30 PM
they came on broncos

Troy
02-05-2008, 05:36 PM
no shit, he has a bronco wanting to upgrade to a 1350 Double Cardan CV driveshaft

i wouldnt bother with a cv they arent too strong, even the high angle driveline ones break right around the yoke ears.

78bronco
02-06-2008, 03:03 PM
I know but Im not sure if I will be able to run a non CV onthe rear cause of the angles.. and the bronco CV's are 1310 or 1330

u2slow
02-08-2008, 11:19 PM
SuperDuties use a 1350CV in the front.

importcrusher
02-24-2008, 10:40 AM
no shit, he has a bronco wanting to upgrade to a 1350 Double Cardan CV driveshaft

i wouldnt bother with a cv they arent too strong, even the high angle driveline ones break right around the yoke ears.
generaly from experience bad driveline angles break cv's and yokes and ujoints too for that matter,you can get a large cv comparable to a 1350 at pats ,it gets a good angle but is not rated for high rpm,works good for a front shaft though around 500 for the cv part

m j
02-24-2008, 03:59 PM
as u2slow said they are from superdutys
you need a custom flange to adapt them to your np205
you may as well call High Angle and buy them from him as he has it all in stock and his prices are way better then Pat's greed
if you can just run the 1330 stuff as it s way cheaper, compare the broncograveyard replacement prices to the bling HAD

78bronco
02-26-2008, 05:35 PM
well the angle on the diff is the same as stock I pitched the pinion up when I lifted it but its has between 9-11" of lift and agreed high angle is cheaper then pats!!

429orangepeel
02-26-2008, 06:06 PM
Dale at Drive Products set me up 1350 CV with a flat faced flange for the 205 and I ran a Dana 70 with no problems and 39.5 Swamps.

Kelowna4runner
02-27-2008, 01:31 PM
double cardnals joints suck ass get a high angle drive shaft ,or a loader joint with a adapter plate too mate up too the t-case

78bronco
02-27-2008, 02:09 PM
double cardnals joints suck ass get a high angle drive shaft ,or a loader joint with a adapter plate too mate up too the t-case

whats a loader joint????