PDA

View Full Version : Asian Locking Hub dial


RUNTOTHEHILLS
11-27-2007, 11:54 PM
When i was rebuilding my 82 axle for my SAS, i took the locking hub dial off the hub body and the clutch was still enganged ( and yes i set the dial to free before taking it apart ), there was no spring and the clutch was just seated on the axle end. Now, just curious as to how i should go about this.. Im going to be getting my front drive shaft made soon and am getting eager to wheel, so ive put this off until now. Do they sell a rebuild kit for this or should i just try to locate another locking hub dial in working condition.. anyone..???:dontknow:

slacker
11-28-2007, 08:39 AM
If there was no spring or the spring was broken , then yes .. get another hub .