PDA

View Full Version : INJECTOR LINE


inprogress
10-02-2007, 02:40 PM
WELL I HAVE A CRACKED FUEL LINE ,#4 FROM THE INJECTOR PUMP TO THE INJECTOR. ITS A 91 CUMMINS NON INTERCOOLED. I HAVE CHECKED THE DEALERS AND NUMEROUS WRECKERS AND AFTERMARKET GUYS,BUT NOONE CAN HELP...ANY IDEAS ,I AM IN NEED BAD!!!!!

bakelite
10-02-2007, 04:49 PM
http://www.knwdiesel.com/

:dontknow: try these guys?

epic3
10-02-2007, 05:03 PM
its just a mild steel line isnt it have a mechanic make one

Trooper
10-02-2007, 10:52 PM
GREENLINE OR A SHOP SIMILAR TO THEM COULD MAKE YOU ONE UP ON THE SPOT MOST LIKELY.
why are you so angry man?

78bronco
10-03-2007, 12:46 AM
what where you doing to crack it???

sj-x 500
10-03-2007, 09:27 PM
hp fuel lines like to crack if you over tighten em.

i would find a good cummins dealer and go there with a CPL.

the CPL can be found on the engine id tag on the timing cover on the front of the engine drivers side

inprogress
10-08-2007, 12:36 AM
i guess one of the hold clamps was missinng and the line rattled too much and just cracked.i am a mechanic and have never seen a flare like this.i talked to everyone i could think of and can't find one.bd said two weeks and 250$ bucks.kinda funny, then he just hung up.seemed like if i didnt have a 60000 dollar truck and another 30000 to put into it,i was just wasting his time...anyway,i might have a line on a used line.what a pain in my ass.temporary fix,i cut a piece of steel tube, made it join over the two ends and then silver soldered it. its been holdin the last week or so. i cant believe how hard it is to find a wrecker with a cummins..

78bronco
10-08-2007, 02:03 AM
I got the same thing when I went to BD looking for parts for my first gen.Guess my money not good enough for them

slowdodge
12-15-2007, 11:09 PM
try pdr in port kells or a dealer