PDA

View Full Version : 3 in body lift


t dogg
08-28-2007, 09:53 PM
i put a three in body lift in my 69 chev, wondering what to do to the steering?? i drilled out the two stock rivits in the steering shaft, should it slide out? couse i cant budge it!

Kinslayer
08-28-2007, 09:55 PM
Yeah, it'll separate, you'll probably have to take it out and heat it up a little bit..throw in a shitload of WD..
Then afterwards drill a new hole and throw in a coathanger, hehe better than new.

I had to put mine in a vice and take a hammer and a punch to free the bitch up

Kinslayer
08-28-2007, 10:00 PM
ooooh, if you have auto you are gonna need to extend your linkage...I just happen to have one that MIGHT work for ya..yours is a 69 so it might not..

Or you could cut and extend it yourself.

Apathy
08-28-2007, 11:20 PM
put a box end wrench over the male end so that it just catches on the outer area, then take a pneumatic hammer tothe wrench.. it'll come righ toff

t dogg
09-06-2007, 07:55 PM
wicked thanx dudes, but kinslayer its a 4 speed. thanks though!

FU Toolbag
09-06-2007, 09:23 PM
so ytou'll just have clutch linkage to mess with.

t dogg
09-22-2007, 06:40 PM
oh yeah, what the best way to do that ,i was thinkn
of simply blockin up the linkage........................???umm ill have to check that out now that im really thinkin of it!!