View Full Version : Driveline angles

08-24-2007, 06:36 PM
How do I know my driveline angles are right?

I get a wicked vibration from the front driveshaft on the highway (solid hubs), and I took my driveshaft into a machine shop and they said it was fine, no problems, so I'm thinkin driveline angles???

08-24-2007, 08:37 PM
Do you get the vibration around 90 to 100 ?

08-25-2007, 12:10 AM
Ruled out everything else? Drove it without the driveshaft in?

Is it a double cardon shaft or single cardon? If it has a DC joint at the tcase, the pinion should point reasonably at it, tolerance is about 2* up or down. If it has a standard single cardon joint, both joints have to be at the same angle. So, the pinion should point flat like the tcase output.