PDA

View Full Version : swapping out 1310 to 1330 yokes


barracuda
08-19-2007, 06:14 PM
i went to change out the the yokes from my old transfer case to the new one (swapping out 1310 to 1330) and found i cant get them off the old case as my 1 inch drive 1-1/4 socket has to thick a wall. works fine with the 1310 yokes . is this a special ford deal? anyone have an idea where to find a thinwall 1-1/4 socket?

This thing is driveing me nuts:fighting0071:

78bronco
08-19-2007, 06:23 PM
just go buy a cheap one and grind it down thats what my dad did.

pumpkin
08-19-2007, 08:24 PM
I have one you can borrow[36]

barracuda
08-19-2007, 08:59 PM
Awsome! Thanks Bob :party0010:

BeerBaron666
08-19-2007, 09:43 PM
I'm pretty sure I have one also it At Johns place if you need it[cheers]

barracuda
08-20-2007, 09:03 PM
I had to drive through langley today so figured i would take a quick peek for a socket at PA & Force just incase they had something before i borrow one. I picked up a 6point 1/2 drive for 9 bucks so i figured what they heck . . I tried when i got home and pulled off the front no problem , I try the rear didnt apply much pressure and the threaded section of the shaft just sheared off:eek: (didnt matter as all i wanted was the yoke) anyone else ever had that happen , another neat thing about this transfer case is when i drained the fluid it was gear oil:eek: how could someone make that mistake? ATF is cast into the housing??? on a positive note it was a very nice pearled colour:D