View Full Version : Dana 60 Semi-float outer pinion seal and bearing
08-16-2007, 08:13 PM
Well, my pinion seal is starting to leak, i'm wanting to change the seal and bearing. I was just wondering if anyone had any tips to changing it, or if there are any special tools needed?
08-16-2007, 09:36 PM
If you don't have an air impact wrench to take the pinion nut off, take rear drive shaft off, use a socket & beaker bar, put it on nut & back up ( I think, back up truck first to see which way it spins) truck to break nut. Have a friend there to watch!!!!
Re-tourque nut to specs.
Not the best way, but hey:dontknow:
08-17-2007, 04:56 PM
Would someone happen to know what size the bolt is that i have to take off the pinion?
vBulletin® v3.6.4, Copyright ©2000-2017, Jelsoft Enterprises Ltd.