View Full Version : cut bronco fenders, kept stock wheelwell chrome
08-12-2007, 12:32 PM
08-12-2007, 12:44 PM
if you keep cuttin the rust away,youll have no truck left :D [cheers]
08-12-2007, 12:48 PM
hah yeah tell me about it....read my sig....beater.
Least it doesnt hurt my feelings when I smash it into trees [cheers]
08-12-2007, 01:28 PM
holy mother of rust...
08-12-2007, 03:13 PM
How big of tires could you fit on there do you figure? I kinda like the stock height with the cut out fender look! You need to do what I did to my 82' Bronco the fiberglass flaired quarters:
08-12-2007, 05:57 PM
If I cut a little more along the bottom edges, and shimmed the front bumper out or cut it then I could fit 35s clean and clear.
...and believe me, the truck needs more than fiberglass 1/4s!
08-12-2007, 08:39 PM
hmm may have to do that to my truck then possibly 39.5s:dontknow: :dontknow:
08-12-2007, 08:51 PM
Yeah, broncos and blazers will fit 35s with trimming pretty easily.
08-12-2007, 11:00 PM
I got 36's no lift with cut fenders and bumper on my 87 and no rubbin
08-12-2007, 11:20 PM
08-12-2007, 11:23 PM
look up fender trimming party in the custom room I think BC_4runner posted some there we cut about three inches all the way round and welded the inners to the outers and reattached the rubber inners to the front fenders
08-12-2007, 11:26 PM
heres tha link http://www.funinbc.com/forum/showthread.php?t=76082
08-13-2007, 09:51 AM
i remember that now...sweeeet
08-13-2007, 10:22 AM
the chrome is rusting your rig why put it back?
08-13-2007, 10:35 AM
i dare you too take the top off and go wheelin......
08-13-2007, 10:55 AM
hahaha yeah right, notice how I dont have the spare on the back? you see that big rust hole on the bottom side of the taillight?...from there all the way to the wheel well and down is not attached to the rest of the body! hahaha
the first time I opened the spare tire carrier it damn near fell on the ground!
08-13-2007, 11:33 AM
i fit 38.5 claws with a 3'' body and cut fenders and minor rubbing on my 91 bronco
08-13-2007, 03:01 PM
how bad was your turning radius
vBulletin® v3.6.4, Copyright ©2000-2018, Jelsoft Enterprises Ltd.