PDA

View Full Version : Question


Murd0c
06-10-2007, 06:54 PM
So I want to put my hub back on, but I can't get the clip the goes on the end of the birf in??? Do I need that for a fact what could I do?

Tried pullin it with the bolt in the end up doesn't move at all so do I need that or what else can I do?

[cheers]

lincoln locked
06-10-2007, 08:59 PM
ya they can be a bitch sometimes ,could you spin the axle freely in the knuckle before you put the spindle on? it needs to be seated properly in the housing with the flat sides of the axle on the top and bottom hope this helps you out , let us know how you made out [cheers]

Murd0c
06-10-2007, 09:03 PM
got her in there fine, couldn't spin by hand (no grip) but turned the front d shaft and it was no problem

lincoln locked
06-10-2007, 09:04 PM
good to hear [cheers]

Murd0c
06-10-2007, 09:05 PM
should I worry about the c clip then?

GOT MUD
06-11-2007, 07:38 AM
what i've done is used a socket that just fits over the axle and put a short extension on it, give it a smack with a hammer and then you just gotta set it in the grove. it works great

Murd0c
06-11-2007, 07:48 AM
I want to pull the axle out a bit not push it in tho?

lincoln locked
06-11-2007, 04:42 PM
ya i would put the c-clip in ,try putting the bolt and washer on the end of the axle and what i use is a large ball joint pickle fork to hook the bolt and washer and pry out the axle it works for me hope it will work for you [cheers]

Big_Ern
06-11-2007, 05:46 PM
[stupid]

The C clip is important and nessessary to stop the axle & birf from sliding in too far and fucking up the 3rd

flipper
06-13-2007, 06:51 PM
Ya, what he said!