View Full Version : reamer??

05-30-2007, 06:10 PM
not sure if this is the right name for the tool, im going to switch my tierods to the top of my knuckles instead of on the bottom, a guy started on them and only got one done before taking off so i only need one reamed out,anybody have the tool to do this or know where i could get it done?

05-30-2007, 06:24 PM
i used a place on river road down by the ferry.. forget the name....

05-30-2007, 06:28 PM
Probably Haney Metal Works... or something of that nature. Just down the road from Gary's Autowrecking.

m j
05-30-2007, 10:30 PM
snap on reamer is about $30
r-121 or something like that rings a bell

I did my steering arm no problem but decided to put the reamer in a drill for the pitman and fawked it up
owned it for about 15minutes before ruining it

05-30-2007, 10:39 PM
is that for a ford tierod or do they all use the same reamer

m j
05-30-2007, 10:47 PM
the angle is pretty much standard 1.5" per foot or someothing like that
the only difference is how deep you ream it

05-30-2007, 11:49 PM
What a jip thats not what i thought this forum was about !
Comon doesnt enyone have a sick mind hahahaa [15] [15]


05-31-2007, 08:24 AM
you want a 7 degree tapered reamer

05-31-2007, 05:10 PM
I don't mean to be picky but 7 degrees is incorrect - it is 1.5" per foot which is 7.13 deg per side.


05-31-2007, 05:14 PM
ok cool thanx for the info guys