PDA

View Full Version : timeing


get stuck
03-29-2007, 01:21 PM
we were trying to set the timeing on my truck and when we got it running good then shut it off the timeing was to far out to start it any one no whats happening [cheers]

BrentG
03-29-2007, 01:27 PM
when it turns over does it pop and puff out the intake; then its too retared if it gets tight what cranking its too advanced

get stuck
03-29-2007, 02:00 PM
yeah a little bit out gas puffs out the carb

BrentG
03-29-2007, 04:44 PM
probably got to advance it a little...
when your setting it have the motor running, turn advanced until it runs rough, then turn it the opposite way till it runs rough, and set it about in the middle. that should be pretty close

get stuck
03-29-2007, 11:07 PM
ok thanks