View Full Version : ball joint spacer for 4runner
02-21-2007, 11:40 PM
has annyone used the ball joint spacers that are off the a-arm on 1st gen 4runners? annyone have a set for sale? ive been looken for a set for a while...wondering if annyone has anny experience with using them or if annyone has anny for sale?
02-22-2007, 03:46 AM
you dont see them used very often...
big ern has a good site for some mroe info on them but we'll have to wait for that for a bit...
good luck finding a used set...
02-22-2007, 05:25 PM
there is a fair amount of info, also if you search around on yotatech (youll have to google it) most of the people on there run them.
I have been debating trying them out also. I figured i have about a .5" torison bar crank right now, if i had a 1.5" spacer, and a 1" diff drop from that site it would be 2" usable lift with not terrible wear on cv boots.:confused0006: :dontknow: But then with a winch it may be too soft? Also some people say the diff drop although claimed at 1" gives more like only .5"? If you find out anything interesting lemme know!
04-22-2007, 09:11 AM
I have run the spacers for about a year now with great results.
04-22-2007, 03:58 PM
The diff drop applies to the 96-02 4Runners and Tacomas
04-22-2007, 06:39 PM
4crawler recently released a 86- 95 diff drop
the difference is it drops the back side of the diff.
one day when I can afford luxuries again i am gonna try out a set!
04-22-2007, 10:17 PM
My bad, didn't realize that. Sorry for the confusion, thanks for the heads up.
04-25-2007, 12:41 AM
I have a set on order and should have them in a few days. There going on my 93 runner but the front ends are the same.
I will post a few pictires when done.
vBulletin® v3.6.4, Copyright ©2000-2018, Jelsoft Enterprises Ltd.