PDA

View Full Version : front driveshafts?


shoobear
12-30-2006, 11:22 PM
Ok, been doing some chevy implants to my scout.
I need the front shaft done now. I have a chevy dana 44 front axle. The stock chevy 3/4 shaft is too short. I need a longer one......did chevy change there front shafts in the blazer,or jimmy? Mine is from a pick up.I need mine to be about 34"Center of u joint to transfter case flange.Might have to get the stock one made longer.Anybody?????

trailburban
12-30-2006, 11:52 PM
only thing that would really change the length of the front shaft in a factory application would be the length of the engine+tranny. so looks like it's off the the welder unless you can find one from a different manufacturer.

drknyght
12-31-2006, 12:00 AM
chev made two different length front d shafts back then.... 1 was the one that came off trucks with 205 t-case's 32" i think, and one that came off the 208 trucks 34" i think, ask a wrecker and they should have samples of both. what kind of t-case you r runnin should dictate the shaft.

FU Toolbag
12-31-2006, 12:13 AM
Weren't they also different depending on tranny? t400 being longer than t350? can't remember where stic fits in and it's too cold to go out and look right now.

shoobear
12-31-2006, 07:24 AM
i am running a 208 for now. With a 4 speed manual.
I have a 205 also. It wont go in until the 208 blows up.
I will phone a wrecker but it looks like it might have to be made.

Kinslayer
12-31-2006, 12:32 PM
Do a square shaft man - any length you want with any yokes you want, and it'll never break.