PDA

View Full Version : 1.6 issues


barracuda
11-07-2006, 01:46 PM
Leah was driving the tracker and she said it all of a sudden started to run rough. It almost sounds like a burnt valve but a compression test shows 175-180 across the board. When the number 4 plug wire is pulled there isnt a huge difference . plugs check out fine plug wires check out fine any other ideas?

In The Zone
11-07-2006, 02:03 PM
is it efi?


any change when u pull 1-3?


with all the recent moisture maybe ignition ststem is wet somewhere?
try some die electric grease on the leads

good luck...

pumpkin
11-07-2006, 02:09 PM
Cap and rotor ? ( this measage is too short)

jakerngr
11-07-2006, 03:41 PM
foweld injector maybe .

ray
11-07-2006, 05:04 PM
check your ingnition plugs at fornt of motor there prone for ruingin plug over time mine whent and i straight wired mine the np plugs have bad connetcion so could be an igniteing proiblem from no power if your ingnigtion plugs bad could be vibrating on and off withc wilkl make it run crappoy and miss and do a hole bunch of other shit

barracuda
11-07-2006, 05:58 PM
Bob Nailed it . Changed the cap rotor and leads and now she is as right as rain[cheers]

230
11-07-2006, 06:01 PM
Rhonda's did the same thing this morning and i a hopeing it is the moisture but i will check it when she gets home.