PDA

View Full Version : bonco motor swap Q???


drew
11-01-2006, 06:21 PM
gota 4.9L inline 6. and what couuld i swap in v8 wise and not have to change the tranny and tranfercase?

Hyenuf
11-01-2006, 07:28 PM
what year Bronco????

drew
11-01-2006, 07:53 PM
1980 ford bronco........

jeepingpw
11-01-2006, 08:46 PM
Only a 302 - 351w, towers are different than the 300's

Hyenuf
11-01-2006, 10:16 PM
How would you like to move up to..... A 460???

Got everything here for ya except the motor mounts!!!!

PM me if you're interested.....

Also got the 351m That is stock in 81....

Maelthra
11-01-2006, 10:33 PM
I took a 4.9L out of my bronco and put in a 5.0L, same Transmission and everything. I just needed new motor mounts and clutch linkage, and I was good to go. I believe the 351w has the same bolt pattern on the bellhousing.

gordwould
11-01-2006, 11:16 PM
4.9L and 302 and 351w same bell housing bolt pattern[cheers]

drew
11-02-2006, 01:55 PM
how much would a decent 302 set me back???

In The Zone
11-02-2006, 02:25 PM
depends where u get it and the condition of it... and what u want to do to it before u install it... still different... efi vs carb vs tbi

personally i would not install any engine before doing all gaskets and checking bearing clearances....heads ect....

so u can go from there...