PDA

View Full Version : where can i get a t-case mount?


G-rizzle Swank
10-23-2006, 06:04 PM
napa and lordco cant find them and the ones they come up with are small and seem to be for a 2wd tranny. do i have to go to toyota directly?
this fucking sucks cus its the only thing holding me back from putting in my dual cases

hilander
10-23-2006, 06:28 PM
try getting one from a wrecker & moding it

Toyquad
10-23-2006, 07:00 PM
wrecker is the best bet..... toyota wants like $100 or something like that for the mount.

exo_toy
10-23-2006, 08:06 PM
i just had one with the xmember. might have thrown it out, ill check tomorrow

TWOZEROFOUR
10-24-2006, 02:01 PM
i have a clean one sitting in my grage. it's mint.. A 12'er and u can come get it ta night

StinkFinger
10-24-2006, 02:02 PM
if you buy new the v6 ones are better

KINGCRUISER
10-24-2006, 06:51 PM
I had a cross member tranny mount built at Kelowna Transmission and Driveline. Fixed the leaking Tcase problem I had, and left room to add skid plates.

Troy
10-24-2006, 06:52 PM
build a custom one......

G-rizzle Swank
10-25-2006, 04:02 PM
i may be a welder, but i dont want to ghetto fab something like that, when i dont have to

StinkFinger
10-25-2006, 04:10 PM
check out the front range off road setup maby its time to fab up som thing like that

trevyota
10-25-2006, 05:22 PM
[stupid]



it's really nice... nothign on the bottom except a skid...

G-rizzle Swank
10-25-2006, 05:45 PM
[stupid]



it's really nice... nothign on the bottom except a skid...



yea i saw yours and was looking at their stuff before, but i have a marlin x-member now so im gonna use that, just wanted the driveline to be solid, hey stinky you said the v-6 ones are better? are they the same as the first gen ones then?

exo_toy
10-25-2006, 07:20 PM
hey greg, you gonna have that thing done for sunday?

G-rizzle Swank
10-25-2006, 10:33 PM
yea dude, its all bolted up except for the x-member, and the x-member is apparently for a newer toyota so its not gonna bolt up, im gonna come by alsek tomorrow im gonna need to fab some angle up so i can make it work for now

the-t-man
10-26-2006, 09:52 AM
hey greg taran here i should know by the end of the day about the t-case rubber mount for a price..