PDA

View Full Version : wheel bearing install


jesslee
09-07-2006, 08:49 PM
anyone got a digram of axle assembly shit or some hints to not fuck anything up?

sj-x 500
09-07-2006, 08:52 PM
front or rear?

joshjohnbaun
09-07-2006, 09:31 PM
both

sj-x 500
09-07-2006, 09:35 PM
fronts are easy, take off hub, , remove snap ring from outer axle, take off the nuts, pull off hub, pound out the races, pound in new, put seal in. tighten down bearings till it is bottomed and tight, then back off 1/8th a turn. set up lock nut, etc.

rear, pull shaft, block up backing plate, and hammer on shaft so that the bearing will be pushed off. careful of the splines, they can get fucked up easy.