PDA

View Full Version : got head gasket??


gordwould
09-06-2006, 12:46 AM
a couple weeks ago went up to davis and on the way into davis i noticed a loss in power and at first i thought it might of been my propain mixer screwing up but then on the way out it got worse to the point it was farting through the mixer so i limped her home and done a compression check the next day to find out there was no compression in 1 and 2 so i ripped it apart to find

gordwould
09-06-2006, 12:49 AM
do these piston look stock[16] but tomorrow im starting to put her back together so here are the pics of what my 351w in my b-2 look like and thanks again jim for the motor[cheers]and i thought i would throw in a pic of the automated lowering system to make it more friendly to work on [f]

In The Zone
09-06-2006, 07:45 AM
Nice head gasket thats a nasty blowout....:eek:



i like the lowering air out coils compresssed......



get her done [cheers]

ray
09-06-2006, 06:40 PM
zone your should look liek tht soon but iwht a 302

gordwould
09-07-2006, 12:24 AM
my bad the head gasket blew between 1 and 2 i guess ive been working on to many chevies lately[27] [27] and i forgot to mension while tearing it down the intake bolts were hand tight and only three bolts per head were over 50 foot lbs of torque so it would explain why it was gutless compaired to my old 302 in my old b-2 especially since i miked the cylinders are 4.000-4.004 stock and these ones are 4.0338=.030 bore and flat tops(10.5-1) and close chamber heads ill check the cc's tomorrow on the one i havent put back on and being properly torqued down(112 foot lbs) and the intake will be torqued properly and the propain being cleaned and serviced and adjusted(opening up the inlet valve for more flow).
cant wait to see how she is going to run :D

gordwould
09-07-2006, 12:26 AM
oh ya dan i still have this 5.0L sitting here waiting for a new home[f]

gordwould
09-20-2006, 01:36 AM
well it's finally back together and runnin like a charm and its amazing how much more power it has now :rolleyes: since it's all back together with the rite torques on the heads and intake the only shitty thing is when i will be able to use it since i have surgery supposably this friday for my right knee but if not im taking out this weekend fo shure[cheers]

In The Zone
09-20-2006, 11:02 AM
Good to here Gord hope your surgery goes well if ya go under....

if not have fun wheelin..

i will be pulling the powertrain for the BII hopefully...

gordwould
09-20-2006, 11:05 AM
you get a motor and stuff?

In The Zone
09-20-2006, 11:11 AM
ya the 302 t18 and bw1356

even though the coolant loss and oiling issues have disappeared in the 2.9


it is a loaded gun ....

im gonna go through the block and shit basic head gaskets pan timing ect... before install..

gordwould
09-20-2006, 12:44 PM
rite on good to hear your going bigger cause they say bigger is better