PDA

View Full Version : bumper mounts


Toy_Runner
08-19-2006, 04:22 PM
what have you guys done to make stronger bumper mounts, i was thinking making a soild piece of steel and drill-tap holes, then weld on top of crossmember, then thst would move my bumper up for body lift

lizard
08-19-2006, 05:13 PM
Iam still tring to figure out something for the front , I put angle iron plates in the rails in the rear .

front I need winch & push bar mounts

gumboot
08-19-2006, 05:41 PM
how about cut those current pieces of angle off the bumper and weld on some square tubing. Then weld another piece of square horizontally on top of your crossmember, you can mount it as high as you want and then mount your bumper onto it. Should be strong enough to handle anything that bumper can take on.