View Full Version : Track Bar Repair..... and then

07-04-2006, 02:26 PM
WoooHoooo [36] [36] [36] [36]

Finally received the parts to do the repair on the front axle track bar mount.

Now I can drive the Bronco again without it shaking itself right off the road. :eek:

Then replace the body mounts a little exhaust work and we are good to go :D

As nasty as the old Ford is it has been brutal not having it to get out in the bushes with............. can't wait [41] [41] [41]

07-04-2006, 02:32 PM
I'll be tippin some celebratory beers with ya buddy [cheers] I miss my tow rig[f]

In The Zone
07-04-2006, 02:36 PM
Good news Jim [36]
will have your mounts done this week....

we miss ya out here....[cheers]

07-04-2006, 06:01 PM
I'll start soaking the body mount hardware in WD40 and maybe some of them will actually just come apart............... well just maybe [27] .

07-04-2006, 06:15 PM
use lloyds move it it works way better than wd

07-04-2006, 07:24 PM
Thanx..........I'll try lloyds.

07-04-2006, 07:26 PM
good news buddy....[36] [cheers]

07-08-2006, 10:47 AM
ive even used good ole liquid wrench with a lil bit of heat and its works gooder than wd [cheers]

07-08-2006, 02:28 PM
Well...........track bar mount is fixed gooder :D

But.......I screwed up the threads on my tre[27]

So... who knows what the thread is so I can get a chaser and fix it.........sure don't want to have to get a new tie rod at this time.
The tre is not replaceable by itself.......gotta do the whole rod:mad:


In The Zone
07-08-2006, 02:59 PM
not sure just count your threads per inch on the tre and get the tap to fix the threaded tierod

07-08-2006, 03:07 PM
The tre is part of the tierod.....not a separate piece.
It's the threads on the ball joint that are fubar.......... don't ask:o

If I can't fix the ball joint I gotta replace the whole tie rod:mad:

I need the correct die to clean up the threads on the ball joint.