PDA

View Full Version : need to change axle/diff seal...


Torch2815
07-03-2006, 04:21 PM
So I had a great weekend up in the Nahatlatch Valley...but got home to find that the front seal at the yoke on the diff housing has pissed out all over the back ent of my truck,So Iam wondering if I just pull the drive shaft undo the large nut in the center and throw in a new seal.I also popped the rear seal on my 205 that mate to the other end of the drive shaft...Any advice on either of these would be appreciated.I also will be checking out a route up there via harrison...

boyzen
07-03-2006, 08:32 PM
you got it

Chody
07-03-2006, 09:11 PM
uh huh

Torch2815
07-04-2006, 04:55 AM
Thanks guys...but it looks like I may have bigger problems now...bearings

In The Zone
07-04-2006, 10:55 AM
the seals are easy but like u said now bearings....


now u got big job



i would believe your rear driveshaft is either bent or out of phase

or not balanced any more

this would wear your seals and eventually deystroy your bearings


good luck...