View Full Version : rear drive shaft?
06-14-2006, 11:35 PM
I have been looking at alot of toyota trucks why is the drive shaft in the rear turned around with the spline side facing the third member? 
06-15-2006, 01:20 PM
why not, is it a problem
In The Zone
06-15-2006, 01:37 PM
that way if you extend past the slip then it aint gonna become a anchor...
06-15-2006, 01:49 PM
there's a bit more clearance there, and the slip part can actually take a bit more of a rub than the thin tube the rest of the driveshaft's made out of.
06-15-2006, 03:21 PM
Thanks for the info. I just couldent figure it out.
06-18-2006, 06:09 PM
another reason is some people use a double cardon jiont on the rear shaft....
vBulletin® v3.6.4, Copyright ©2000-2018, Jelsoft Enterprises Ltd.