PDA

View Full Version : dana 60 hp kingpin......


Squishy
05-27-2006, 05:18 PM
trak lok carrier.... can i put a lockrite/aussie in there or do i have to find an open carrier for that. also, will a low pin. open carrier work? i know the gears wont because there reverse cut, but the actual carrier?

barracuda
05-27-2006, 05:23 PM
as long as it is a 35 spline carrier it should work

boyzen
05-27-2006, 05:29 PM
can not put a lockrite in a trac loc carrier

Nutbar
05-27-2006, 05:32 PM
the carriers are the same for low and high pinion diffs but you can't use the track lock for the lock rite/aussie installs

barracuda
05-27-2006, 05:42 PM
sorry for not being specific but i was only refering to the low pinion open carrier fitting as long as the spline count was the same and it was the correct split . (rev cut dana 60 gears normally fit 4,10 and down carriers regardless of ratios numericly higher then 4.10 )