PDA

View Full Version : flywheel machining


gumboot
05-14-2006, 07:53 PM
so wheres the best place to get a fly wheel machined in kelowna?

shockless
05-14-2006, 07:53 PM
use an angle grinder

sparky
05-14-2006, 08:00 PM
lordco does it on site cost 25-35 bucks they will do it for free if u buy clutch there.........[cheers]

jay_bob
05-14-2006, 08:50 PM
i used ok engine builders i got them to balance the flywheel too because i just put a 400 small block in everything is good so far

Growly Gorilla
05-15-2006, 07:30 AM
lordco does it on site cost 25-35 bucks they will do it for free if u buy clutch there.........[cheers]


[stupid] [cheers]

adrock
05-15-2006, 09:42 PM
k&s machine. in the process of having them build my 383. talk to dave