View Full Version : High angle front driveshaft
05-08-2006, 02:18 AM
Need to get a high angle front driveshaft made for my 78 1ton on 44's any suggestions?
05-08-2006, 07:40 AM
tom woods offset ujoints , no cv
get the front dif cut n turned before buying a shaft
run 1410 at the front
eliminate axle wrap entirely
05-08-2006, 09:44 PM
05-09-2006, 05:59 PM
i thought about gettin it cut and turned but thats a fair bit of coin i heard its easier on the pocket to just get a high angle driveshaft made
a driveshaft will not solve anything
you will spit the front ujoint out, the CV might be capable of running at stupid angles but the one at the pinion will not.
there is no "cheap" way to make a driveline survive
[stupid] [stupid] ...cheap just means fix it often
05-09-2006, 07:55 PM
what would it cost aproximately to have it cut and turned?
05-15-2006, 05:19 PM
I'm going bigger so post the results on what you do.
vBulletin® v3.6.4, Copyright ©2000-2017, Jelsoft Enterprises Ltd.