PDA

View Full Version : Rear drive shaft


joshjohnbaun
01-26-2006, 07:07 PM
Hey, im lookin at buying a 88 samurai, but its missing the rear drive shaft... and was wondering would the shaft from a tracker fit? also, does anyone have one?

JamesT
01-26-2006, 07:21 PM
you need one from a samurai

there are different size flanges also, being an '88 it could be either size.

szabotage
01-26-2006, 07:41 PM
trackick's have a slip yoke at the transfer case end so they won't work

the diff end tho has a yoke that can be used on pre 88.5 samurai driveshafts that are bigger and stronger. you just need to redrill new or bigger holes into the flange. post 88.5 sammis share the same yokes and flanges as the diff end of a trackick DS.

FINGERS
01-26-2006, 08:18 PM
just make one mang!!!

Zukbuilder
01-26-2006, 08:26 PM
Don't fit. . .but I have tracker one if you want some fabrication.

joshjohnbaun
01-27-2006, 08:15 AM
anyone know of where to get one??? or know of anyone who has one to spare?, truckworks is guna cost me 3-4hundred

rimlak
01-27-2006, 12:12 PM
i was recommended to look at a place near frightliner...i dunno what it is called...it is a palce for driveshafts...

harleyfatboy99ca
01-28-2006, 07:51 PM
I had a hard time finding parts for mine, but I picked up a Toyota front drive shaft, so far it's the same length. I haven't bolted it in yet, but if you turn it on the rear flange and drill new holes it will work and a lot stronger.

NIGHT RANGER
01-28-2006, 09:06 PM
Go to either Pats driveline or Drive products in Port Kells should be much cheaper and they know what they are doing!
Night Ranger

Cheeky
01-28-2006, 11:07 PM
look for a used on,my drive shaft at Pat's was 400.00:eek: try Alpi's in surrey,they prob got 1 for ya[cheers]

joshjohnbaun
01-29-2006, 07:40 PM
ah i dont need one anymore, not gettin that zuk.. wants too much for it...