View Full Version : ranger/b2 front diff tech

01-20-2006, 01:23 AM
so i got a dana 35 for my b2 but it has no hubs or calipers my question is are either of those the same as the dana 28 like will my calipers fit and or hubs on the 35 from the 28 and is it true that i will have to shorten my front drive shaft

01-20-2006, 01:41 AM
i[!] on your thread


In The Zone
01-20-2006, 07:04 PM
yes to the driveshaft

and no to your hubs and shit

01-20-2006, 08:59 PM
I had to shorten my driveshaft about an inch and a half.

01-25-2006, 10:25 PM
yeah u have to shorten the drive shaft and no nuttin will fit

01-25-2006, 10:47 PM
if you lift it enough I wouldn't think you'd need to shorten it??

I assume its different because of the longer pinion, so more lift should compensate.

just talking out my ass, i could be completely wrong. Never looked at a ttb setup that close before

01-25-2006, 10:54 PM
chunks this is where I got alot of the ideas / Info for my b2 ;

Rangerstation.com or BroncoII.org

If u pull a drive shaft outta a new ranger with 5speed and a dana35 that would work. They arnt that much, like 40$ I think thats what I got mine for.

02-23-2006, 10:22 PM
like they said

no the d28 hubs wont work

driveshaft needs to be shortend its easy to do though
if you get stuck for hubs i have some mint autos lol

02-24-2006, 11:46 PM
Dont shorten the driveshaft silly,lengthen the truck.

02-25-2006, 09:48 AM
pull the whole shit out and put in a solid axle out of a heep...

02-26-2006, 04:00 PM
a d35 is better than a shit ass d30 from a jeep even if it is a solid axle vs ttb

In The Zone
02-26-2006, 04:22 PM
the problem with the d35 is narrow bearings.....

Always broke
02-26-2006, 05:21 PM
Can you say S A S?

[15] [15] [15] [15] [15] [15] [15] [15] [15] [15]