View Full Version : wheel spacers

01-19-2006, 12:09 PM
anybody here running wheel spacers? if so how do you like them???

01-19-2006, 12:12 PM
I'm not running wheel spacer. instead i swapped the IFS hubs & caliper with FJ40 rotors for an extra 3" width (1.5" each side) Works great and no added stress on the wheel bearings. plus you get bigger brakes with vented rotors

01-19-2006, 02:10 PM
I wish I was running them.

01-19-2006, 06:47 PM
I run spacers on all for corners and I love them never had any problem.

01-19-2006, 08:07 PM
I got spacers up front to keep the tires off the frame.

01-20-2006, 10:01 AM
what width are you guys running?

01-20-2006, 02:29 PM
I run 1.5" spacers on each side up front, no problems, they work great! In the rear, Ive matched the width with a 92 60" wide v6....if you get spacers, run the ones with there own lug studs comming out, so you have 12 lugs to torque per side. Ive seen some getto cheaper ones guys have bought that are 1-1.5" that slide over your existing lug studs, but of coarse you have to replace all the originals lugs with 2.5 studs. not so cool

01-20-2006, 02:32 PM
adding the IFS hub swap matches the widetrack rear end out of an IFS rig, so if ou only need to widen the front its a really good way to go. Especially if you're doing a SAS and already have the old IFS parts laying around.

01-20-2006, 07:41 PM
I run 1.5" spacers..they work, no problems so far
I think I should swap in some ifs gear and make it even wider hmm
sounds like fun wideness

01-20-2006, 07:57 PM
Mine are only half an inch

01-20-2006, 08:53 PM
im running 2 1/2. just make sure there good and tight.

01-30-2006, 08:30 PM
Loose a wheel or two Gildavin....hehehe

01-31-2006, 01:52 PM
i have 2 1/4" spacers (only 2 thow) and i dont need them anymore because i am going with the 3/4ton axles

01-31-2006, 09:43 PM
hey tin420 if you need some spacers i have 1.5" 6-5.5 let me know??

02-01-2006, 08:01 AM
im interested...how much do you want for them?