PDA

View Full Version : Re: 6" Lift in Blazer


zeeker
09-17-2005, 07:25 AM
New Here...
I am putting a 6" Superlift suspension kit in my 89 full-size Blazer.
And need some info regarding driveshaft lengths for front and rear.
also any other problems that I might run into.

Thanks...Zac.

Blazer
09-17-2005, 07:38 AM
you should be ok for driveshaft lengths after you drop the trans cross member(1 in), on some you have to motify the trans cross member for the front drive shaft. The main problem with the blazers is getting the pinion angle right so you don't eat up U-jionts.
Hope this helps.

http://www.propertytours.ca/cdnflag.gif
cleverly disguised as a responsible adult.
http://www.cardomain.com/ride/2051588


75 Blazer 6in lift hacked fenders 350/4 spd 205tc stitting on 36/1450/15 swampers

Larry
09-17-2005, 07:41 AM
i dont know, sorry but i have a 6 inch susp lift in my 92 chevy fullsize

Alan Says.....

It's Five O'Clock Somewhere

zeeker
09-17-2005, 08:45 AM
Thanks Blazer...I'll watch that. Is there a kit for the trany mount?

redneck_justice
09-17-2005, 10:09 AM
some picks ups have the drop spacers in them u will see them when ya look underneath it's just longer bolts where the c-member bolts to the frame and looks like a 1 inch piece of pipe around the bolt to drop the c-member an inch. u could prob just cut some pipe and put the longer bolts in just make sure ya use strong enough bolts.phil

HEAVY METAL
09-17-2005, 10:15 AM
[stupid]

-----------------------



JESUS DID IT FOR THE CHICKS...