PDA

View Full Version : pivot bushing tool (Fords Special tool)


outdoorextremist
07-13-2005, 11:56 AM
According to the haynes manual for my f-250 you need a specal tool to remove and install the pivot bushing in the dana 50 IFS, well as I was reading this manual, which tells you little about how to do it, but shows you instead, I was looking at this tool and realized, hell I have this tool in the appliance repair show I work at, its the same tool that maytag calls their specal tool, that we use to remove tub seals in the Amana washers, and I bet that this one cost alot less. so now when I go and do this bushing, screw the ford shop, I will just use the one I have here...

just a tidbit of info for you all.

now if it make sence or not is another story

91 Ford F250 4x4, 302 on propane,with shorty headers, and 33" tires.
I am No redneck, I am a Backwoods hillbilly

tazuki
07-13-2005, 12:08 PM
Try this ! [22]

Image Insert:
http://www.funinbc.com/forum/uploaded/tazuki/200571318822_hamer.jpg
6.54KB

"What for you bury me under the cold cold ground"

outdoorextremist
07-13-2005, 12:45 PM
thats what I am going to use, but it was just a observation...

91 Ford F250 4x4, 302 on propane,with shorty headers, and 33" tires.
I am No redneck, I am a Backwoods hillbilly

shockless
07-14-2005, 04:21 AM
haha thats what i used

__________________________________________________ ______________________
87 F250 300/4.9l/ stock running gear/3:54s
mods: k&n filter,3 inch trailmaster body lift,31's,roll bar, warn manual hubs,
coming soon:
in the middle of a sas
"I lifted my truck cause fat chicks cant climb"