PDA

View Full Version : axle tube diameter


shockless
06-07-2005, 07:49 AM
what is the diameter of a hp d44 axle tube?

__________________________________________________ ______________________
87 F250 300/4.9l/ stock running gear/3:54s
mods: k&n filter,3 inch trailmaster body lift,31's,roll bar, warn manual hubs,
coming soon:
in the middle of a sas

shockless
06-07-2005, 08:19 AM
anyone???


__________________________________________________ ______________________
87 F250 300/4.9l/ stock running gear/3:54s
mods: k&n filter,3 inch trailmaster body lift,31's,roll bar, warn manual hubs,
coming soon:
in the middle of a sas

Squishy
06-07-2005, 12:49 PM
ill go measure right now


__________________________
1984 Bronco II, 302, NP435,NP208 Doubler, NP205,5.13 Dana 44/8.8 Fullwidth, Detroit, Coil Front, 36" Militarys

Insurance Covers Everything But What Happens.

Got MonoFoam?

barracuda
06-07-2005, 01:21 PM
3 inch OD with .5 inch thick tubes for an 8 bolt Dana 44 HP and it is about 3.75 around the housing section. I am guessing you are doing a U-bolt flip . I am useing 9/16 ubolts all around and they were about 10.90 each custom made from scott spring including nuts and washers .

http://www.funinbc.com/forum/uploaded/barracuda/card.gif

"A level" mobile welder
mig,tig,alum spool,stick
rates start at $65 an hr
welder rental from $125 per day


The way to a mans heart is through his zipper!!!

shockless
06-08-2005, 06:31 AM
haha im actually making spring perches but ubolt flip is next thanks

__________________________________________________ ______________________
87 F250 300/4.9l/ stock running gear/3:54s
mods: k&n filter,3 inch trailmaster body lift,31's,roll bar, warn manual hubs,
coming soon:
in the middle of a sas