PDA

View Full Version : taper size for the 1T tie rod end


Stu_Dawg
01-20-2005, 06:46 AM
hey im wondering what the size of the taper is for the 1T tie rod end, buying the reamer.

"If it ain't a chevy, don't raise it up" - snoop dogg

I'll be bringing spark plugs, to throw at people i dont like...LIKE YOU!!!!

Broncoo
01-20-2005, 11:21 AM
1.5" per foot


http://www.stockcarproducts.com/susp13a.htm

i have no idea what to put here

m j
01-20-2005, 03:49 PM
the same taper as every other tierod and draglink you should not need to ream anything for a tierod
what part numbers are you using fr your tierod ends?
the real one ton stuff uses a 1"x18tpi

if ou are making a draglink use the high angle draglink ends es2026 and es2027 thqat are found on every chev truck from at least 73-87

_________________________
I am trying to feel sorry for you but I just can't seem to do it.

DanB
01-20-2005, 04:58 PM
hes going to make highsteer stuff and need to ream the holes for tierod to go in..

for draglinks and tierod he is planning on making them too

m j
01-20-2005, 06:22 PM
no one uses the 1 ton stuff
everyone uses the 7/8" 18tpi parts

http://www.partsmikeparts.com/tre_comparison.htm

check that link out
use .219wall1.25"DOM tubing
the ID is about right for threading to 7/8" 18tpi

you can get the taps for around $200
or for the $200 cost of the taps I will make you the rods
I have 20' of the DOM here ready to go
tell me what ends you want to use and I will cut and tap the tubing :)

_________________________
I am trying to feel sorry for you but I just can't seem to do it.