PDA

View Full Version : SWAMPER QUESTION


BIGBLUE92
11-05-2004, 10:24 AM
ANYONE KNOW HOW FAR DOWN A 38' TSL SWAMPER CAN BE RE-GROOVED??? IVE HEARD A QUARTER INCH.....IS THIS ACCURATE...NEED TO KNOW ASAP

92 TOY V6 38"S 529'S 9 INCH LIFT

"Gotta get a little mud on the tires" - Brad Paisley

crimsen
11-05-2004, 01:15 PM
find someone with the same tire, start at 1/4 inch, and keep going till it starts to leak air, then back off 1/8 or so and go home and grouve away :)

------------------------
79 F150 custom
open dana 44 under 4" BDS coils
welded 9" under 4" arched leafs.
3.57 gears
35x16 tsl boggers
351 m with edelbrock performer 400 intake and edelbrock 600 carb
on board air
np 205 T case
np 435 tranny

For Off Road Driving

BIGBLUE92
11-05-2004, 01:43 PM
ALRIGHT WHOS GOT SOME 38.5X14.5X15 SWAMPER SSX'S HAHA

92 TOY V6 38"S 529'S 9 INCH LIFT

"Gotta get a little mud on the tires" - Brad Paisley

m j
11-05-2004, 06:03 PM
the fawking things are bald, toss em

boyzen
11-05-2004, 06:19 PM
If you have bias you might not even bother unless you are just doing the tread block,If you go down past the base of rubber you will create a real piece of crap they get so flexible that it has no stablility they also go out of round and do not run over anything pointy cause it can go right through.I know cause I went through that a few years ago on some ground hawgs try to gain more grip I just wrecked them, and I only went down 1/4 inch.

Image Insert:
http://www.funinbc.com/forum/uploaded/boyzen/20049132203_ani6.gif
25.13spudKB