PDA

View Full Version : Grooving tires


hamberger
02-12-2004, 09:00 PM
Does anyone have a grooving tool. Not necessarily for re-grooving but to "alter" an existing tread design.

ham

DanB
02-13-2004, 04:48 AM
some people say just use sawzal it would work fine..

i might use skillsaw for my tires those lugs on 52 tires are huge

dentedup
02-13-2004, 05:57 AM
I did mine with a skill saw, worked great

72cruiser
02-13-2004, 07:26 AM
i used a router to do mine and it works awsome you can set the depth so you dont cut in to the cords

boyzen
02-13-2004, 03:46 PM
I used a 1" hole saw that I gound sharp like a knife then hooked it on a drill and cupped the rubber out worked really good and very cheap.


Buy some boggers....

DanB
02-13-2004, 03:54 PM
keep those ideas coming along
:) i like the router idea (need to buy one or borrow one

imported_n/a
02-17-2004, 09:48 PM
use an angle grinder a little smoky but it works

84 yota, 7 inch lift, locked front, rear, 5.29's, boggers, leather seats, and a whole lot of other thingys

Guybc
02-20-2004, 08:50 PM
yeha, i used a angle grinder, haha , do it outside thats what i suggest, not in a warm shop like i did