PDA

View Full Version : Custom TTB Extended Radius Arms?


Squishy
11-27-2003, 03:11 PM
I was thinking of doing something along the lines of cutting the radius arm before the thread and welding on a piece of tube to extend the radius arm mounting point on the frame. anyne done or herd of this being done before?

90 Ford F150

BroncoDan
11-27-2003, 04:49 PM
http://www.bentandtwisted.com/ makes extentions for 78/79 style radius arms but I don't se any reason why they wouldn't work for a ttb arm.

I dont think that they have them listed on there site but IIRC they were $60 US a pair

check out this threadhttp://fullsizebronco.com/forum/showthread.php?s=&threadid=6847

richsworkshop
11-28-2003, 06:01 AM
With the TTB style arms it can be cut and an extention added towards the front of the arm. Since it is sheet steel, it is just a matter of cutting/bending the required pieces, cutting and welding!

The solid bar extention also works, but probably works better with the early arms (forged) rather than the stamped arms, just by design.

That's my 2 cents[3]

Rich [}:)] (aka Stax)
"It's ALL GOOD!"

TTC 2003
Been there... done that... waiting for the video!
http://www.funinbc.com/forum/uploaded/richsworkshop/2003826141541_business_card.gif