PDA

View Full Version : Need a hydraulic press


Toyrantula
08-03-2003, 09:25 PM
Since I am sitting around and the Toyota is going no where soon, I figured I might try pulling the front end out of my truck and putting the lift in.

I am thinking if I need to burn the bushings out I "may" need a press to put the new ones in and the bushings etc.

Not a for sure I will need one, but would be nice to know if one is available.

Thankx[36]

A GOOD friend will bail you out of jail,

A BEST friend will will be sitting beside you saying"that was fawkin` awesome!"

YJJAY
08-03-2003, 09:50 PM
Cant youo just use a sawsall to cut the fuckers out???

http://www.funinbc.com/forum/uploaded/YJJAY/2003293720_136.gifAm I human??--No...I'm a meat popcicle!<div align="right">check out my buddies band at...www.radiokiller.org</div id="right">

KBB
08-04-2003, 08:10 AM
Drill them out. Takes a little longer but no special tools needed


One AREO DYNAMIC CHALLENGED 350TBI,rvcam,sm465,np241,D44-detroitelectrac,c14ffgovloc,4-10gears,r-sliders,6-prollcage,37mtr's on 15x10 steelies,9000winch,electricooling,shower,tracbar,r eversal shackles,4"s-lift,1.5"b-lift,lots of recovery equipment,swaybar disconnects,cb