PDA

View Full Version : Clutch fan tool


Trailjunkie
06-17-2017, 10:07 AM
Ok I'm replaceing the water pump in my 2003 f350 7.3 liter power stroke. I hear I need this wrench for the removal of the clutch fan . Any one have one I could borrow for next weekend? Anyone done one of these and know any tricks to make it easier /faster?
Thanks

harvester_sorrow
06-18-2017, 10:55 AM
Cut one out of flat bar?

Apathy
06-19-2017, 10:49 AM
I was able to remove it with a big pair of channel locks. Did not need the tool. On another note, when you get the water pump. spend the money and get the one that has the inlets and outlets already on it.(some you have to take yours off and put on the new pump) They are a PITA to get sealed. I did mine, then had to do it again due to leaks. I did not head the warning from a friend.. :(

Apathy
06-19-2017, 10:54 AM
http://www.dieselsite.com/ProductImages/waterneck.png
This guy can be a PITA to seal

pumpkin
06-19-2017, 09:57 PM
I use and air chisel, but a hammer and chisel also works well.

4skin
06-20-2017, 06:29 PM
It's left thread I believe