PDA

View Full Version : Exaust question


Tunabomber
01-01-2014, 07:21 PM
Im tryn to gather parts for phase 1 of make my hoe 4 wheel drive.

Need to relocate the stock exaust.

The easy and cheap way is to unbolt from the minifold and go dual

I have the mufflers and the pipe but my question is this

The o2 sensor is in the collecter that joins the 2 manifold into one just before the cat..

Where would i put the o2 sensor on a dual set up?

StinkFinger
01-01-2014, 09:36 PM
jut put it in one bank as close to the maifold as you can

Nutbar
01-01-2014, 10:12 PM
[stupid]

StinkFinger
01-01-2014, 10:54 PM
why closer to the manifold ?
im glad you asked

if you run it in one bank it will run cooler than in the two if it dosent get hot enough it dosent work right

4skin
01-02-2014, 01:01 AM
why closer to the manifold ?
im glad you asked

if you run it in one bank it will run cooler than in the two if it dosent get hot enough it dosent work right

Unless its a three wire then it's heated

Tunabomber
01-02-2014, 01:25 AM
Sweet thanks.

Soo as close to flange as possible one one side

StinkFinger
01-02-2014, 07:24 PM
Unless its a three wire then it's heated

eve with a heated o2 youll have problems as generaly its a pre heat ad ot constent

Nutbar
01-02-2014, 07:52 PM
always try to mount it as close to the engine as you can get it, will give you the more accurate response time. Heated O2s just respond quicker therefore more accurate than non heated.

C-Dog
01-03-2014, 12:27 AM
Man it's heated in here




Must be am the O2 talk

4skin
01-03-2014, 08:16 PM
This thread is exhausting to read