PDA

View Full Version : egr been gone for few yrs and wondering...


godtool
03-26-2013, 05:53 PM
I took of egr valve off my early 80's 305 v8 and just fitted a homemade plate over hole and engine still runs good. Yet was wondering if I should have blocked passage in intake or does it matter? I had disconnected all the emmission stuff too since it was just a bush truck and wanted minimum spots for a vacuum leak and max hp out of the 305. I had a 750 quadrajet on it too but the acclerator pump is shot so just about to rebuild a 650 QJ for it since it may run better with 650. Ideas? |I'm not so concerned about hp till I can put bigger engine in.

godtool
04-02-2013, 02:53 PM
Found out all I needed to do was cap it off like I did.